How to use the Audio Clean-Up Assistant

I just installed the plugin. What’s next?

Open your host, and load Audio Clean-Up Assistant like any other ERA plugin. You can find details for this process in this section of our Help Center: How to open ERA Bundle plugins in your DAW or NLE.

How does this plugin work?

That’s simple! Select any of the available ERA single-knob plugins and load them in one of the empty slots. You can do this by selecting the plugin from the dropdown menu above each slot.

Sounds cool, but which plug-in should I open first?

Good question!

If you’re not sure how to start setting up a proper plug-in chain, have a look at the Preset Menu of the Audio Clean-Up Assistant. Our engineers have created some high-quality factory presets that may help you quickly find an effective starting point depending on common cases. See how to take advantage of the Presets.

Can I change the plugin settings?

Yes! You can control all plugins separately so that you can adjust the result to your needs.

Can I remove a plugin?

Click on the dropdown menu, and select “Empty this slot”.

I have adjusted the plugin settings but I am not sure if they are correct.

The A/B switch on the top corner is the key here. Click on it and compare the two different plug-in chains Then, keep the one you prefer more!

Can I compare my settings to the original audio file?

Sure! Click on the “On-Off” switch to completely bypass the Audio Clean-Up Assistant. When the Assistant is off, you will see a “BYPASSED” message next to the switch.

I have found my desired settings. What’s next?

You are good to go! But… before you go, store your plug-in chain using the Preset menu, so you can use it again in a new project.

Then, you can export your audio or video and enjoy the results of your personal plugin chain.